Slime dryer slime dryer principle of slime dryer technology 
 Coal drying expert Zhengzhou Dongding dry for many years engaged in the slime, clean coal and coal dewatering drying, and accumulated a wealth of experience and theory and practice of corporate slime drying system has been updated to the seventh generation. Slime has a certain viscosity, wet slurry into the dryer during the drying process after the following areas: First, a conducting zone, wet slime of exposure to the rapid evaporation of water into this area with high-temperature hot air, the material in the big lead do not form a bond will be imported under the corner copy board copy a work area; two cleaning up area, wet slime copy copy board in this area so he took the formation of the state of the material curtain fall of the material is easy to form a bonding roller wall phenomenon in this area due to equipment design and cleaning device, cleaning device, it is very reasonable to clean up the inner wall adhesion of the materials in this process, the cleaning device for the material group ball agglomeration also play a crushing effect, thus increasing the heat exchange area, to improve the drying rate; tilt lifting plate area, wet slime loose state in this area has shown a low moisture, the material in this area does not have a bonding phenomenon, after heat exchange material to reach the required moisture status entered the final feed zone; four is a feed zone, the drum in this area is no copy board, rolling glide materials in this area to the discharge opening, to complete the drying process. 
 The Zhengzhou Dongding to welcome you to inquire. 
 Helpline 0371 -8,623,311,186,233,222 
 Phone: 18937160179 
 0371 -86,638,070 
 Website; http://www.dddry.cn, http://www.dddry.com 
 Address: Zhengzhou City, to be water Industrial Park